Jabsco 920-0003-P Nitrile Impeller Kit 8-Blade 2-9/16" Spline Drive

The Jabsco 920-0003-P is a flexible nitrile impeller featuring 8 blades, measuring 2-9/16 inches (65mm) in diameter by 2 inches (51mm) thick, with a 5/8 inch (16mm) brass spline drive shaft hub. This replacement impeller is designed for marine engine cooling and bilge applications, as well as industrial processing applications.

Key Features:

• 8-blade design with brass spline drive insert for reliable performance
• Nitrile construction ideal for bilge pumping and transfer duties where water is heavily contaminated by oil or diesel
• Handles a wide range of fluids including oils, diesel fuel, kerosene, and lubricating oils
• Operating temperature range of 50°F to 180°F (10°C to 82.2°C)
• Subjected to rigorous quality processes to ensure reliable, efficient and long lasting performance

Jabsco flexible impellers can be fitted to most makes and models of engine cooling water pumps, bilge pumps, transfer and general purpose pumps. Replace all impellers at least once every year, or sooner, depending on the engine duty. Always grease new impellers to make installation easier and provide added protection during initial prime.

Important Note: Nitrile impellers are softer and will give a reduced rated flow 10 percent below the listed pump performance. Flexible impeller pumps need up to 30 seconds to prime but should not run dry longer as lack of liquid will damage the impeller.