Airmar MM-10FUR 10-Pin Furuno Adapter Cable for 600W Transducers

The Airmar MM-10FUR is a 10-pin adapter cable designed to connect Airmar Mix and Match 600W non-CHIRP transducers to Furuno marine electronics. This 8-meter brand-specific cable features an Airmar 5-pin female connector on one end and a Furuno 10-pin connector on the other, allowing you to connect your Airmar transducer base unit to your Furuno fishfinder or chartplotter.

Mix and Match System Benefits:

The Mix and Match system provides flexibility for boaters who may change electronics brands. The transducer itself comes with a short 2-meter pigtail ending in an Airmar 5-pin male connector, while this MM-10FUR adapter cable provides the remaining 8 meters of length with the Furuno-specific termination. If you upgrade to a different electronics brand in the future, simply replace the adapter cable while leaving the transducer installed in your hull.

Key Features:

• 10-pin Furuno connector for compatibility with Furuno 10-pin equipment
• 8-meter (approximately 26 feet) cable length
• Airmar 5-pin female connector interfaces with Mix and Match transducer base
• Designed specifically for 600W non-CHIRP transducers
• Allows transducer reuse when changing electronics brands

Important Compatibility Note:

This cable is designed exclusively for 600W Mix and Match transducers. It cannot be used with 1kW transducers or CHIRP transducers. Both the transducer base unit and this adapter cable are required for complete installation.