Transducer Shield and Saver TM-H8.3 Protective Shield for Humminbird Solix and Helix Mega SI Transducers

The TM-H8.3 is built in high quality alloy and black powder coated, designed to protect Humminbird Solix Mega G2N/G3N and Helix Mega G3N/G4N side imaging transducers from damage during operation and installation.

Compatible Transducers:

• Humminbird Solix Mega G2N or G3N Si GPS Transducer (XM 14 HW MSI T or XTM 14 HW MSI T)
• Humminbird Helix Mega G3N or G4N Si GPS Transducer (XM 9 HW MSI T, XTM 9 HW MSI T, or XM 14 HW MSI T)

Key Features:

• Sleek hydrodynamic design cuts through the water for less drag, especially on trolling motors
• Reduces collection of debris and keeps the transducer positioned correctly
• Will not interfere with transducer signal transmission
• Can be installed on trolling motors, jack plates, hole shot plates, or set backs
• Compatible with L Brackets and Wedges for various mounting configurations

Installation Notes:

• For trolling motor installation, two mounting straps are required (sold separately)
• Trolling motors with front skeg may require additional Ram Rail Kit for proper fitment
• When mounted on set back, hole shot plate, or jack plate side, an in-hull transducer is recommended for bottom tracking at planing speeds

This professional-grade transducer shield provides essential protection for expensive marine electronics while maintaining optimal sonar performance in all fishing conditions.