Acme Automotive 5999 Traditional Weekend Saver C-Clamp Prop Puller Kit 1-1/4" Shaft

The Acme 5999 Traditional Weekend Saver Prop Puller Kit is a complete propeller removal and spare-carrying solution designed for inboard boats with 1-1/4" prop shafts and propellers ranging from 16" to 18" in diameter. Whether you're swapping a damaged prop on the water or performing routine maintenance, this kit has every tool you need to get back on the water fast.

Inboard boats use a tapered prop shaft that causes the propeller to seat tightly under load, making hand removal difficult or impossible. The included 330S C-Clamp propeller puller applies controlled mechanical force to break the taper seat cleanly, without damaging the shaft, hub, or surrounding hardware.

Kit Includes:

• 330S C-Clamp propeller puller (1-1/4" shaft)
• Padded soft-side carrying case (holds a spare propeller)
• Adjustable wrench
• Needle-nose pliers
• Nylock prop nut
• Stainless steel key
• Cotter pin

Important Note for 1-1/4" Shaft Applications: Some newer inboard wake and ski boats (2015 and newer Malibu, Axis, Centurion, Supreme, Tige, and ATX) may use a non-standard 3/4-10 thread size instead of the standard 7/8-9 thread. Verify your thread size before ordering. If needed, consider the 1-1/4" Special Nut Kit (ACME #5266MAL) or non-standard nut part #5003.

Propeller is not included. This kit is sold as a tool and hardware set only. Also available in a smaller shaft size configuration: the Acme #4999 kit fits shafts from 1" to 1-1/8" and propellers up to 15.5" in diameter.