Airmar MMC-11R-LDB Mix & Match CHIRP Adapter Cable 11-Pin Low & Dual-Band for Raymarine

The Airmar MMC-11R-LDB is a 1-meter Mix & Match CHIRP adapter cable designed to connect compatible Airmar low-band and dual-band CHIRP transducers to Raymarine fishfinders and chartplotters equipped with an 11-pin connector. Also known by Airmar part number 33-1357-01, this short adapter cable is the brand-specific link in Airmar's flexible Mix & Match system.

Airmar's Mix & Match CHIRP system uses a two-piece cable architecture: a permanently attached 9-meter transducer cable ending in an Airmar 12-pin female connector runs from the transducer up through the hull to the equipment location. The MMC-11R-LDB then connects between that 12-pin cable and the Raymarine display, providing the brand-specific 11-pin termination for low-frequency and dual-band CHIRP transducers.

Key Features:

• 1-meter (approximately 3.3 ft) brand-specific adapter cable for Raymarine 11-pin displays
• Compatible with Airmar low-band and dual-band Mix & Match CHIRP transducers up to 1 kW
• Airmar 12-pin male connector on one end connects to the transducer's 9-meter cable; Raymarine 11-pin connector on the other end connects to the sounder or display
• Allows the base transducer to be used with any compatible brand of sounder simply by swapping the short adapter cable
• If the display brand is changed in the future, only this adapter cable needs to be replaced—the transducer and its 9-meter cable remain in place
• Compatible with all CHIRP transducers regardless of power rating

Important Note: CHIRP Mix & Match cables, including the MMC-11R-LDB, are not compatible with conventional 50/200 kHz (non-CHIRP) transducers. Both the 9-meter base cable and this adapter cable are required for a complete installation.