Seaview Plastic Vertical Cable Seal for Wire up to

The Seaview plastic vertical cable seal, also called a cable gland, CableClam or deck seal, gives marine electronics, power and other cables a watertight pass-through. It suits boat decks, RV roofs and other panels where a cable has to enter vertically.

Key Features:

• Split seal design: You can install it without removing the cable connectors.
• Watertight installation: A tapered rubber plug and a base gasket seal the entry point.
• IPX6 and IPX7 waterproof rating: Tested for protection against water ingress.
• Low-profile design: The impact-resistant plastic construction has no sharp edges and gives a clean installed look.
• Multi-cable capable: The base works with more than one cable if each cable has its own hole and at least 0.125 inch of rubber surrounds each hole.

Seaview mounts and accessories are used by recreational boaters, commercial operators and yacht builders. This cable seal helps keep wiring tidy, protected and sealed against the elements.