Rule Industries LP900S LoPro 900 GPH Automatic Bilge Pump 12V Low Profile

The Rule Industries LP900S LoPro™ Automatic Bilge Pump delivers 900 gallons per hour of pumping capacity in an ultra-compact, low-profile design built for the tightest bilge spaces. At just 2-1/4" tall, this 12V submersible pump fits under engines, in deep keel sumps, and in shallow bilge sections where standard bilge pumps simply won't go.

Dual Automatic Operating Modes:

• Water Level Sensing Mode: Automatically activates when bilge water reaches a user-selectable depth of 2" or 1.3" — flip the motor cartridge to switch between settings
• Electronic Check Mode: Pump turns on every 2.5 minutes to sense for water; if detected, runs continuously until the bilge is dry

Key Features:

• Fully rotating discharge body swivels up to 180° for easy plumbing and installation
• Attached hose swivels 360° for optimal hose routing
• Includes four threaded discharge port fittings: 3/4" straight, 1" straight, 1-1/8" straight, and 3/4" 90° elbow
• Tricuspid check valve included for the straight fitting to minimize backflow
• Cartridge-style motor assembly for simplified servicing and replacement
• Mounts horizontally or vertically to suit any bilge configuration
• Completely submersible with moisture-tight seals
• Rust and corrosion-resistant construction with stainless steel shaft
• Marine-grade sealed wiring and ignition protection
• Anti-airlock protection and silent, vibration-free operation
• Easy-clean snap-lock strainer base
• Capable of running dry without motor burnout
• CE and ISO 8849 certified
• 3-year limited warranty

Specifications:

• Flow Rate: 900 GPH (3,407 LPH)
• Voltage: 12V DC
• Amp Draw: 4A
• Recommended Fuse: 7.5A
• Height: 2-1/4" (5.7 cm)
• Discharge Ports: 3/4", 1", 1-1/8" straight; 3/4" 90° elbow

The Rule LP900S is an ideal solution for protecting shallow bilge compartments, deep keel sumps, and confined engine bay areas. No separate float switch is required, making installation straightforward and reliable.