Bob's Machine 100-114001P-PCGBLK-NOSPN-NG Action Series 14in Hydraulic Jack Plate Black Powder Coat

The Bob's Machine Action Series 14" Setback Hydraulic Jack Plate (MPN: 100-114001P-PCGBLK-NOSPN-NG) delivers powerful, responsive outboard motor height adjustment in a sleek black powder coat finish. Engineered for serious anglers and performance boaters, this all-in-one hydraulic jack plate features an internally mounted pump that keeps rigging clean and installation simple — just run wires to the battery and switch.

The one-piece design eliminates the need for setback spacers to reach the 14" setback dimension, providing a rigid and streamlined structure right out of the box. The large, powerful hydraulic motor provides 7.5 inches of total lift — including 6 inches of adjustable travel — and can raise heavy outboards under full power in approximately six seconds.

Key Features:

• 14" Setback — one-piece design, no C-channels or spacers required
• 300 HP / 625 lb rated — supports outboards with mounting widths up to 14.5"
• Integrated hydraulic pump — internally mounted for clean rigging; convertible to inside-boat pump mounting if desired
• 7.5" total lift with 6" of adjustable travel and 1.5" of inherent lift capacity
• Black powder coat finish for corrosion resistance and a clean, stealthy appearance
• Automotive-style grease nipples on side rails for easy lubrication and extended service life
• Adjustable tension rods in the frame to maintain alignment and control under heavy loads
• Pre-drilled for dual side-mount Power Pole shallow water anchor brackets (sold separately)
• Includes jack plate, wiring harness, relays, and rocker-style switch
• Made in the USA
• Limited lifetime warranty on structure; 5-year warranty on hydraulic pump

The Action Series hydraulic jack plate improves outboard boat speed, hole shot, fuel efficiency, and shallow-water performance by enabling precise on-the-fly engine height adjustment. For outboards wider than 14.5", Bob's Machine recommends upgrading to their Extreme Gen3 series. Note: Yamaha motors with integrated steering require an optional 1" spacer set installed between the jack plate and motor.